This is dictated by cost and the desire to insulate. It’s possible to build well insulated buildings that look traditional, but it’s going to cost more and it’s not going to improve the quality of living inside the house.
Flat rectangular insulation panels with plaster on top placed on large flat surfaces -vs- irregularly shaped insulation with a cavity and a bespoke brick façade. Just the bricks alone, so without the labour, is going to cost about the same as the finished plaster. In the long term brick and a sloped roof should require less frequent renovations, but I doubt that it would ever offset the higher initial cost.
Yeah, I’m looking into insulating my 100+ year old house, and it might mean the stones on the base need to be flattened and covered up. The windows and some of the doors are now plastic, since the previous ones (that were already not the original) were water damaged, which somehow involved the indoor doors too.
You can stick a fancy facade on basically any wall construction to make it look like an old-half timbered style, or brick, or stone, etc.
But trying to actually build an old brick/stone/plaster and timber monstrosity today wouldn’t be smart. Insulation, moisture control, energy efficiency, and even creature comforts like wifi signal penetration are all miles better with newer construction methods.
I agree the architecture is boring, but again, it doesn’t have to look this way. However, I think most people would rather have the soulless gray box than have uncontrollable mold spreading across their walls unless they leave the windows open in winter.
This is dictated by cost and the desire to insulate. It’s possible to build well insulated buildings that look traditional, but it’s going to cost more and it’s not going to improve the quality of living inside the house.
Flat rectangular insulation panels with plaster on top placed on large flat surfaces -vs- irregularly shaped insulation with a cavity and a bespoke brick façade. Just the bricks alone, so without the labour, is going to cost about the same as the finished plaster. In the long term brick and a sloped roof should require less frequent renovations, but I doubt that it would ever offset the higher initial cost.
Yeah, I’m looking into insulating my 100+ year old house, and it might mean the stones on the base need to be flattened and covered up. The windows and some of the doors are now plastic, since the previous ones (that were already not the original) were water damaged, which somehow involved the indoor doors too.
You can stick a fancy facade on basically any wall construction to make it look like an old-half timbered style, or brick, or stone, etc.
But trying to actually build an old brick/stone/plaster and timber monstrosity today wouldn’t be smart. Insulation, moisture control, energy efficiency, and even creature comforts like wifi signal penetration are all miles better with newer construction methods.
I agree the architecture is boring, but again, it doesn’t have to look this way. However, I think most people would rather have the soulless gray box than have uncontrollable mold spreading across their walls unless they leave the windows open in winter.
In Australia, you can get the soulless grey box with shit insulation and mold problems, so it’s twice as good! /s